BEOWELD / How to use

Check the fitting.
Then make the seal.

Identify the sealing surface, follow the application steps, and keep the checklist with your toolkit.

The BEOWELD fitting check

A thread holds it together.
But where does it seal?

Some threads make the seal. Others simply tighten a nut around an olive or washer. Identify the sealing surface before choosing a sealant.

Which best describes your connection?

Before you buy

Find the seal.
Then choose the sealant.

BEOWELD Liquid PTFE is for suitable metal-to-metal connections that seal at the threads. Choose your connection to see what to check next.

Read the five-point checklist

A fitting can have different types of connection at each end. Check the exact joint you’re working on and its manufacturer’s instructions. If you cannot identify the sealing surface, get advice from a qualified installer before proceeding.

Learn how these seals work: compression fittings — Beswick Engineering · push-fit connections — John Guest.

Application basics

Prepare. Apply.
Assemble. Cure.

Start with a suitable metal threaded joint. A careful application matters just as much as choosing the right sealant.

Step 1: PREPARE

Clean the threads.

Remove old sealant, oil and debris. Make sure the mating threads are clean and dry.

Step 2: APPLY

Add a bead.

Apply a thin, continuous bead to the male thread.

Step 3: ASSEMBLE

Bring the joint together.

Assemble the fitting and tighten as required, following its manufacturer’s instructions. Wipe away excess sealant.

Step 4: CURE

Give it time.

Allow curing time before pressurising the system. See the pack guidance for cure times.

This is an overview. Read the product label and safety information before use, and check suitability for your fitting and application.

BEOWELD / A guide to keep

Five checks.
Before you seal.

Keep this checklist handy for your next suitable metal threaded joint. No email needed.

  1. Identify the sealing surface.

    Confirm the joint seals at its mating threads, rather than an olive, washer, gasket or O-ring.

  2. Check both mating materials.

    BEOWELD Liquid PTFE is for suitable metal-to-metal threads. Check the fitting and product instructions for your application.

  3. Inspect and prepare the threads.

    Check for damage. Remove old sealant, oil and debris, and make sure the mating threads are clean and dry.

  4. Apply and assemble as instructed.

    Apply a thin, continuous bead to the male thread at an ambient temperature of 5–50°C. Follow the fitting manufacturer’s assembly procedure. Wipe away excess.

  5. Allow the specified cure time.

    Follow the product instructions before putting the joint into service, then check it using the system’s prescribed test procedure.

This checklist is an overview, not a substitute for the product label, safety information or fitting manufacturer’s instructions. If you are unsure about the joint or application, ask a qualified installer.