The short answer

Usually, PTFE tape is not needed to form the seal in a standard olive-type compression joint. The olive seals against the pipe and fitting; the nut’s threads provide the tightening force. However, manufacturer instructions differ on lubricants and sealing aids, so check the exact fitting before adding anything.

The threads tighten. The olive seals.

A visible thread does not always mean a threaded seal. In a typical compression connection, the nut squeezes a ring called an olive around the pipe and into the fitting body. That contact makes the seal—not the screw thread that moves the nut.

Flowflex explains this distinction in its compression-fitting guidance. Wrapping the nut’s thread does not turn it into the sealing surface. The useful first question is therefore: which surfaces are meant to stop the water?

Why do people give different advice about tape?

Some disagreement comes from treating every compression fitting as identical. Flowflex says tape is unnecessary for the compression seal, allows optional use on threads for lubrication, and advises against applying it to the olive.

Kuterlite’s manufacturer guidance includes different, specific provisions: it describes tape or an approved compound on sealing faces for certain situations, including a slight weep. That is a product-specific instruction, not permission to wrap every olive.

Neither “always use tape” nor “never use tape” is a reliable universal rule. Follow the current instructions for the fitting, pipe material and service. A method approved for one range may be wrong for another.

One adaptor can have two different sealing methods

A compression-to-threaded adaptor makes this especially easy to misunderstand. Its compression end uses an olive; the other end may require a thread seal or a washer, depending on its design.

For example, Kuterlite distinguishes taper male threaded connectors, which use a specified jointing material, from certain parallel male connections that use a jointing washer. Identify each end separately rather than applying the same treatment to the whole fitting.

For a broader comparison, read PTFE tape vs liquid PTFE.

What should you check if the joint weeps?

For an ordinary water connection, first establish where the water actually comes from. Water running down a pipe can make an innocent joint look faulty. Before dismantling, isolate the supply, release pressure safely and let hot pipework cool.

Check the fitting instructions against the pipe size and material, the pipe’s condition and insertion, and the condition of the olive and mating surfaces. Kuterlite stresses clean, undamaged components and correct preparation.

Do not keep tightening blindly or use a generic number of turns: the appropriate assembly method depends on the fitting. If the cause is unclear or a leak persists, have a competent plumber assess it. This guide is not a procedure for gas fittings.

Would liquid PTFE be a better fix?

Not automatically. BEOWELD Liquid PTFE is intended for suitable metal threads that form the seal. Our product guidance excludes compression fittings, so we do not recommend it as a repair for an olive seal.

An approved jointing compound named by a fitting manufacturer is not interchangeable with every product sold as “liquid PTFE”. Check the exact product and application.

We sell thread sealant, but there are joints where you do not need it. Understanding the connection is more useful than choosing a sealant first. Our fitting suitability guide helps you make that distinction.

Written by BEOWELD. Manufacturer guidance consulted on 11 October 2026. This overview focuses on conventional olive-type compression joints; use the current instructions for your exact fitting and application.

Sources and further reading

Know what makes your joint seal.

Threads, an olive or a washer? Start with the fitting before choosing a sealant.

Check fitting suitability