The short answer
Possible causes include an unsuitable or disturbed seal, dirty or damaged threads, incorrect assembly, or putting a curing sealant into service too soon. Start by identifying where the joint actually seals. More tape, more sealant or more tightening is not automatically the solution.
Make the system safe first
This guide concerns identifying possible causes, not repairing a live leak. Safely isolate and depressurise the system before inspecting or disassembling it; allow hot components to cool. If you cannot do that safely, stop and get a qualified installer.
Do not loosen pressurised fittings or try to stop a leak with your hand. Suspected gas leaks require emergency advice from your gas network or emergency service, not this DIY checklist.
1. Is the thread actually making the seal?
A visible thread can just hold a washer, gasket or olive in place. Putting tape or liquid sealant on that thread does not repair the separate sealing component. A push-fit connection uses another sealing arrangement again.
Identify the fitting from its documentation. Our fitting guide explains the differences. BEOWELD Liquid PTFE is not for compression fittings, push-fit connections or plastic threads.
2. Were the parts clean and suitable?
Debris and poor thread condition can affect sealing. Inspect safely dismantled components and confirm their specifications match the intended connection. Do not force parts together or use sealant to compensate for damaged threads.
Clean and prepare the surfaces as specified by the fitting and sealant manufacturers. Replace unsuitable parts rather than repeating the same assembly with extra product.
3. Was the connection assembled correctly?
Insufficient tightening and excessive tightening are different problems. Overtightening can damage threads; a generic “one more turn” instruction is not a reliable repair method. Follow the instructions for the exact fitting.
With tape, check the application instructions, including wrap direction and quantity. A taped joint that was loosened to reposition it may need to be remade. Do not assume that adding liquid sealant over the outside will repair the joint.
4. Was the sealant ready for service?
An assembled anaerobic-sealant joint is not necessarily fully cured. Check the instructions for cure time and application conditions before pressurising it. For BEOWELD, use the current packaging guidance rather than another brand’s stated time.
See how to apply BEOWELD Liquid PTFE for the preparation, bead, assembly and cure sequence.
If the leak returns
Have the connection and operating conditions assessed by a qualified installer. A repeated leak deserves a diagnosis rather than repeated tightening. Test any completed repair using the system manufacturer’s prescribed procedure.
For a BEOWELD product question, use our private enquiry form with the fitting type, materials and product used. For help choosing between sealing methods, read our tape versus liquid comparison.
General assembly guidance draws on Swagelok’s manufacturer resources; BEOWELD application guidance comes from our product directions. These checks cannot diagnose a particular installation remotely.
Sources and further reading
Find the right size for your toolkit.
Explore BEOWELD Liquid PTFE in 10ml and 50ml, with purchase links to Amazon.
Compare bottle sizes